|
Problem in C5707 Transistor in BenQ T705 LCD Monitor This BenQ T705 LCD Monitor has a common fault of display shutdown after few you "On" for few seconds. The cause of the problem was usually a shorted one or two of the C5707 push pull transistors. Besides the shorted transistor, one also has to check the tuning capacitor for high ESR value with the help of ESR meter. [VIEW ARTICLE]Comments RSS Feed For This Article: 
2
 Gilberto Cavada writes:Subject: C5707 transistor Thanks. It is the first time that I work with LCD monitors and I had the good fortune to find this wonderful article. it is more than I was looking for, it exceed my expectations about some one trying to help. Thanks again. Comment provided October 12, 2009 at 8:47 am
|
|
|
| ARTICLE COMMENT GUIDELINES |
| Important Disclaimer: Article Comments provided on any EzineArticles.com article are for general information purposes only and are not intended to substitute for informed professional medical, psychological, tax, accounting, legal, investment, or any other professional advice. EzineArticles.com expressly disclaims liability for any product, manufacturer, distributor, service or service provider mentioned or any opinion expressed in these comments or anywhere else within the site. Lastly, EzineArticles.com does not endorse any article comment. Use at your own risk. |
© EzineArticles.com - All Rights Reserved Worldwide.
Subject: BenQ monitor repairs
Excellent fault finding and diagnosis report which should help avoid hours of wasted time for our engineering colleagues. It is a shame that most manufacturers fail to share this type of useful support information!
Kind Regards Mike Woods (Automation Engineer)